PRINCO CORP.
886-3-5773177
886-3-5787958
No.6, Yanxin 4th Rd., East Dist., Hsinchu City 300, Taiwan
www.princo.com.tw/tools

Products

Coating Offering
Punching and Forming

Princo's coatings are only a few thousandth of a millimetre thick, but harder than steel and chemically inert. That's why they sustainably reduce tool wear, cold welding and friction. Tools with Princo's coatings significantly boost productivity and quality in punching and forming operations.



Princo's coatings can :

Lower costs


Due to less tool wear, reduced lubricant consumption, fewer tool failures and calculable tool changes. You can cut manufacturing costs across the board.

Boost productivity

Due to substantially longer lives, higher cycle frequencies, reduced machine idle time and less workpiece finishing effort. You can punch, form and fine-blank with greater cost-effectiveness.

Enhance quality

Due to smoother surfaces, better dimensional stability, higher degrees of metal deformation and fewer manufacturing steps. You can establish higher standards in manufacturing.

Reduce environmental impact

Due to the use of environmentally friendlier lubricants, reduced lubricant consumption or even dry machining. You conserve resources and spend less on consumables.

Optimise tool production

Due to Princo's cutting tools. You can manufacture your punching and forming tools faster and at lower cost.


































Dies and punches uncoated TiCN coated
Rework 100'000 parts 250'000 parts
Total tool life 100 % 500 %
Savings for 

1 million parts
0 USD 9'000

Clamps 

steel strip 2.5 mm, 500 N/mm 

Source 

Balzers


















Tool 

Forming punch 

Workpiece 

steel sleeve 

uncoated 

no production possible 

TiCN - coated 

tool life 90'000 parts 

tool cost USD 1'382 

tool cost per part USD 0.014 

Source 

Balzers


Specification

Mold
Machine
Vehicle
Contact Supplier
Browsing History
Scroll Up
EZB2B.TW uses cookies,IP to collect data and continually improve the website. By continuing to use this website, you must agree to the use of cookies and IP.